Racor T-Handle Vacuum Restriction Indicator Gauge

Features:

• Indicates when it is time to change your diesel fuel filter
• Designed for use on all Racor 500 / 900 / 1000 Diesel Fuel Filters
• Gauge measures the increase in vacuum due to contamination of the Filter
• T-Handle Vacuum Restriction Indicator monitors the diesel filter's condition as the filter becomes clogged with contaminants
• The T-Handle gauge accurately measures filter contamination with any size micron filter
• As the filter gets dirty, restriction increases and less fuel is delivered to the engine, causing the engine to lose power and eventually stall
• Fits all Racor Turbine Series Diesel Fuel Filter / Water Separator assemblies
• Installs in one easy spin. Simply remove existing T-handle and replace with the RK32348 T-Handle Gauge. (Not a Kit / Fully assembled / Complete with O-ring)
• T-handle design allows for filter cover removal / installation without tools
• Maximizes fuel filter life and Lengthens fuel filter change out intervals
• Easy to read:
• Locks in position at highest measured filter contamination level
• When the Yellow internal indicator approaches the Red Zone, Change the Filter. (Red Zone indicates 10” Hg vacuum) Green Zone ” Good To Go”
• 360° Viewable
• The gauge can be read anytime, even days after the engine has been off
• Internal Check Valve:
• The T-Handle has a check valve to allow usage with priming pumps and prevent leaks if the gauge is damaged
• Easy and Safe Reset Button:
• Located on top of gauge / Never opens gauge to the outside atmosphere
• Works as a Diagnostic tool for other fuel problems:
• Helps to Diagnose: ( After filter change)
• Collapsing fuel lines
• Bad / Closed fuel valves
• Clogged fuel pick-ups
• Heavily Contaminated fuel tanks
• Takes the guesswork out of diesel fuel filter maintenance:
• Maximize filter life, Stop Guessing when to change filters
• Know immediately when bad fuel is pumped onboard
• All components are 100% Diesel Fuel Compatible
• Use with diesel, bio-diesel, and kerosene
• Lowers operational costs / down time
• Helps to keep unnecessarily changed filters from being discarded
• Made in the U.S.A.

Specifications:

• Accuracy: ± 10%
• Calibration: 10 inHg (34 kPa) at Red zone
• Material: Brass and Chemical Resistant Nylon*
• 2.5 “ (6.4 cm) higher than original T-Handle / Over all height 4.8” (12.2 cm)
• Operating Temperature -40° to +250°F (-40° to +121°C)