SHURflo Pump Head Kit
Status: In Stock
- SHURflo® part #94-236-14 is a pump head replacement kit for the following 2088/2093 Series Pumps:
- Silencer™ Premium
- Standard Blaster™
- Pro Blaster™ Junior
- Pro Baitmaster™ Junior
- P/S 3.0
- Cam: 3.0
- PSI: 45
- Pump head unit
- (3) Screws
- (2) Heat shrink connectors
Replacement Instructions (see figure below):
- Disconnect lead wires from pressure switch. Note which wire goes to each lead on the switch.
- Remove the strain relief plug by pushing out on the plug from the motor side with a flat blade screwdriver. Pull the lead wires through the strainer relief.
- Remove the three long screws. These screws hold the pump head assembly to the motor.
- Remove the pump head
- Place the new pump head on the motor shaft.
- Put the three long screws in place and screw down until each touches; then tighten each screw securely.
- Attach the lead wires onto switch.
- Place the strain relief in original position.