Seaview Cable Gland - Gray ABS Plastic - 1 or 2 Cables

The Seaview Retrofit Cable Gland (CG30PG2) provides a watertight installation for one or two of your currently installed cables. Whether you are replacing a damaged cable gland or installing one where there should have been one, this split cable gland is the only guaranteed and proven watertight installation for your currently installed cables.

Features:

• Provides a waterproof pass-through for antenna, transducer, lights, power and other cables without removal of the factory installed cable connector
• Tapered rubber seal forms watertight installation
• Base gasket also provided for clean water tight installation
• No need to re-run your cables - split cable gland works easily if the cable is already installed or you have a new installation
• Does not require connector removal during install, however you still have to consider cable diameter
• Each cable gland is supplied with a blank rubber seal that has a molded location to drill and cut
• Captive nuts make for easy assembly
• Low profile design for a strong, impact-resistant and clean installation (no sharp edges to hit your foot on)
• Inner rubber seal is flush with the top of the cable gland so that water does not have a place to collect
• Waterproof: IPX6 and IPX7 tested and approved
  • IPX6 test means these pass 100L/min of water sprayed from 2.5 to 3 meters away for 3 min.
  • IPX7 test means these pass a 30 minute submersion under 1 meter of water